The car every 2 years 40 thousand km: vehicles this time has been running in period, the parts are full of activities. This is the peak of the vehicle, but some oil and liquid closed cycle almost all at this time of change, is commonly known as the "maintenance".
The moisture absorption ability of brake oil is very strong, so every 40 thousand kilometers all the best replacement, ensure the normal function of the. The spark plug can be replaced. In order to keep the engine cooling effect. At the same time, can the water in the water tank replacement, to avoid scale deposited obstruct the circular, and by adding appropriate water tank. At the same time, every two years to do a tire for vehicle positioning, of course, have to do to change a tire positioning immediately.
Car every four years about 7 to 8 million kilometers: this part parts of the vehicle began to appear signs of aging, but need not worry, as long as the usual maintenance in a timely manner, these parts are just update after the condition has been able to maintain good. The service life of transmission shaft dust cover about four years, if the drive shaft dust cover broken, easy to cause the universal joint wear, leading to turning the front wheel when abnormal sound, if serious wear, whole drive shaft will need to be replaced. Recommended every five thousand km maintenance, check to see if the damage is. Belt idler as long as cracks or loose slip should be renewed, the belt wear will produce the sharp sound of friction, will increase with the engine speed and high, is easy to identify. In addition, there is the engine foot of the rubber buffer pad aging problem, this little thing is bad when the most obvious impact is the engine jitter. The engine is the use of the time period is almost the same, and weekdays can take advantage of every 5000 km maintenance technicians to help pay attention to their situation.
In order to ensure the normal operation of the transmission shaft and prolong its service life, we should pay attention to:
1 no car with high speed gear start.
2 do not toss the clutch pedal.
3 prohibited vehicle overloading, speeding.
The 4 should always check the working condition of the transmission shaft.
5. Should always check the shaft hanger fastening, rubber bearing is damaged, drive shaft of each connection part is Songkuang, transmission shaft deformation.
6 in order to ensure the dynamic balance of drive shaft, should always pay attention to the balance sheet or desoldering welding. When the driving shaft assembly is to provide matching, with the new dynamic axial loading should pay attention to the telescopic sleeve assembly mark, should ensure that the flange yoke in a plane. In the maintenance of removing the drive shaft, the telescopic sleeve and shaft flange should be printed on the assembly mark for re assembly to keep the original assembly relationship unchanged.
7 should often Cardan bearing grease, the summer should inject 3 lithium grease, winter into the No. 2 lithium grease. |